120M HDMI To LAN Port RJ45 Network Cable Extender Over by Cat 5e/6 1080p Black
Extend 1080 FULL HD HDMI signal to 120meter through a Cat-5e/6 cable.
Using CAT-5E/6 Cable instead of HDMI cable to achieve long distance transmission
HDTV Resolutions 480p576p720p1080p HDMI 1.3 HDCP 1.1 and DVI1.1 compliant.
Audio Sample rate: 32kHz 44.1kHz and 48kHz
IR remote control 38KHz; NEC
Introduction
HDMI Over Ethernet is based on TCP/IP standard. It transmits your HD display with the high resolutions up to 120 meters away from your HDMI or DVI-D source by using one CAT5e/6 cable. With the advantage of TCP/IP standardyou can extend your HD video to multiple displays by using an Ethernet Switch.
HDTV Resolutions
480p576p720p1080p
Audio
Sample rate:32kHz44.1kHz48kHz
IR remote control
38kHz;NEC
HDMI
HDMI 1.3
HDCP
HDCP 1.2
Power adapter
Input100V-240V(50-60Hz) Output:5V/1A
Power consumption
HDMI Sender:3W HDMI receiver:3W
Size(L-W-H)
92x79x20mm
Weight
240g x 2
Operating Temperature/Humidity
0-70/10%-80%RH(no condensation)
Storage Temperature/Humidity
-10-80/5%-90%RH(no condensation)
Specifications
Ø Following TCP/IP standard.
Ø Support HDMI1.3 protocol.
Ø HDCP1.1 & 1.2 protocol compliant
Ø Support point-to-point mode one point-to-many mode and cascade connection mode.
Ø Support IR extender function allows IR remote control of Source devices from remote viewing location by sending IR commands received in the vicinity of the Display back to the Source devices.
Packing contents:
1) Main unit No. 1 Sender Main unit No. 2 Receiver
2) Two pieces of 5V DC Power Supply.
3) one piece of IR transmitter and one piece of IR receiver
4) User’s Manual
5V/1A
Supply power for the Transmitter
Reset
Hold down the keythe model will re-start
IR-out
Connect IR transmitter this Port
HDMI-in
Connect HDMI sink source to this Port
HDMI Receiver
5V/1A
Supply power for the Receiver
Reset
Hold down the keythe model will re-start
IR-in
Connect IR Receiver this Port
HDMI-out
Connect HDMI sink device to this Port
Connection and operation
1) Connect the HDMI source (such as DVD PS3 STB ) to the HDMI IN of Sender.
2) Connect the IR sender to the Sender IR OUT Port and Be Directed at HDMI video source’s IR receiver.
3) Connect the HDMI out of Receiver to HDTV display.
4) Connect the IR receiver to the Receiver IR IN Port.
5) Use one Cat5e/6 cable up to 120m to connect the Sender and Receiver.
6) Plug two pieces of 5V power supply into the Sender and Receiver.
7) Power on the HDTV display and HDMI source.
(4.67)
